1.Stay on the first floor until the Up Button is pressed for a higher floor.

2.Wait for all passengers to get on or off before responding to any up commands.

3.After 20 seconds close the door when closing doors if any resistance when closing then open doors and wait for ten seconds then attempt to close the door again.

4.When the Up Button is pressed, move to the requested higher floor.

5.If the up button is pressed and the elevator already in motion upward DO NOT respond to any down button requests before completing designated stops in chronological order.

6.Stop at each floor in ascending order then wait for 30 seconds, slowly close doors however if any force is sensed between doors immediately open wait for 10 second then attempt to close again if resistance is felt again repeat this process until doors can be closed without hassle.

7.Once you have reached the top floor after allowing 30 seconds for passengers to get off then start responding to down button requests.

8.Move down towards the lowest requested floor where the Down Button is pressed.

9.If the down button is pressed, stop at the designated floor in descending order.

10.Stop at each floor where the Down Button is pressed wait for 30 seconds before attempting to close doors if no resistance close doors and repeat.

11.After responding to all Down Button requests if there are no remaining requests return to the lobby floor and open.

12.Once passengers are off then remain on first floor until elevator is called to a different floor or a passenger enters it