Elevator instructions—couragethecowardlydog

Posted on September 15, 2024 by Courage The Cowardly Dog

  1. Stay on the lobby floor until the up button is pressed and all the passengers get off or on
  2. Once the up button to go to a higher floor is pressed, respond to those commands
  3. stop for half a minute at each floor that was pressed from the inside of the elevator floor
  4. If the button is pressed to go up from a higher floor, stop on those floors as well
  5. Once the elevator hits the top floor, then it should start responding to down commands
  6. stop at each floor that hit the down button and wait 30 seconds for passengers to get in before closing or wait for the close button
  7. After responding to every down command stop on the lobby and let the remaining passengers get off
  8. Once all the passengers are off start over the whole process.

Posted in CourageTheCowardlyDog, Elevator Instructions | Leave a comment

Elevator Instructions – waffles121

Posted on September 15, 2024 by waffles121
  • Remain idle at Floor 1 until an Indication Button is pressed by a commuter.
  • The Indication Button will either be the Up Button or the Down Button.
  • When the Indication Button is pressed either open the doors if the button was pressed at Floor 1, or move to the floor that the button was pressed on if the indication came from a higher floor.
  • Once the elevator doors are open, leave them open for a minimum of 20 seconds.
  • If there are blockages that are preventing the doors from closing then remain open until the blockages have cleared.
  • After the commuter has entered the elevator and pressed a Floor Button to signal the floor they would like to arrive at, commence motion.
  • Move to the floor number that corresponds to the Floor Button that was pressed uninterrupted unless an Indication Button is pressed by another commuter during the trip.
  • If another commuter presses a button for a floor that the elevator has yet to pass, then stop on the floor that the signal came from and repeat the process of opening and closing the doors mentioned previously in Step Two.
  • Move to all of the desired floor and allow the commuters to exit. 
  • Once all commuters have reached their destinations and all of the commands given by the Indication and Floor Buttons have been executed, return the elevator to Floor One. 
  • Remain idle until another commuter presses an Indication Button and activates the elevator again. 

Posted in Elevator Instructions, Waffles | 2 Comments

Elevator Instructions—Elongated Lobster

Posted on September 15, 2024 by Elongated lobster
  1. Remain on the lobby floor until the summon button is pressed
  2. If the button is pressed for the lobby, open the doors to the lobby and allow 15 seconds for passengers to enter and to press the button for the floor that they wish to exit at
  3. After 15 seconds, close the doors as long as there are no appendages or passengers in the path of the door that would prevent the doors from closing, or that would result in harming a passenger
  4. Once the doors have closed, proceed to the next closest floor that has had the corresponding button pressed
  5. Once at the corresponding floor number, open the doors and allow 15 seconds for any passengers wishing to exit to get off or passengers that wish to get on to enter
  6. After 15 seconds, close the doors as long as there are no appendages or passengers in the path of the door that would prevent the doors from closing, or that would result in harming a passenger
  7. Proceed to the next floor that has had the corresponding button pressed and repeat steps 5 and 6 for each floor that has had the corresponding button pressed
  8. If no summoning button on any given floor has been pressed for 30 seconds after all of the floors that have had corresponding buttons pressed have been visited, proceed back to the lobby until a summoning button has been pressed again
  9. If a summoning button has been pressed while in the process of proceeding back to the lobby after the 30 seconds, stop, and go to the floor corresponding to which summoning button was pressed
  10. If the close door now or door stay open button is pressed before the 15 seconds on each floor are up, either close the door, or stay open until button is released, depending on which button is pressed
  11. In the event that the emergency stop button is pressed, stop immediately, and send a signal to the front desk to contact the police and fire department to aid in the emergency

Posted in Elevator Instructions, Elongated Lobster | 1 Comment

Elevator Post—Student 1512

Posted on September 15, 2024 by student1512

-A passenger may use the Summons button outside of the elevator in order to call it to the first floor.

-If there are currently passengers within the elevator, drop off said passengers at the corresponding levels in the order of which the passengers got on the elevator. Then, lastly, arrive at the first floor at which the elevator has been summoned.

-If there are no passengers currently on the elevator when summoned to the first floor, go directly to the first floor.

-When at the first floor, stop the elevator, open the doors for the passenger, and wait fifteen seconds for inactivity before closing the doors.

-If no activity is detected, close the doors.

-Do not move up or down to any floors until the passenger selects a floor level.

-If the passenger presses the “Floor 3” Summons button, wait three seconds before beginning to move up to Floor 3.

-Should the elevator be requested to go to Floor 7 while the current passenger is on their way to Floor 3, go to Floor 3 first, let out the passenger, and then go to Floor 7.

-When reaching Floor 3, stop the elevator and wait three seconds before opening the doors. At which point the current passenger will exit the elevator. 

-Continue to wait for fifteen seconds of inactivity before closing the doors and going up to the passenger that hit the Summons button on Floor 7.

–Repeat the same process used to bring the first passenger to their requested level.

-When completed with the final passenger and not summoned to any other floor, return to the “Home” level. This would be the First floor. 

-Wait at the home level, with the doors closed, until summoned by other passengers.

Posted in Elevator Instructions, Student1512 | 1 Comment

Elevator Instructions—lobsterman

Posted on September 15, 2024 by lobsterman

Get Off My Elevator

  1. When the down button on the fourth floor is pressed, go to the fourth floor.
  2. If passengers are on board, wait for them to get off.
  3. If passengers on the fourth floor delay entering, it is because someone on the fifth floor has pressed the up button on the fifth floor.
  4. After visiting the fifth floor, the passengers on the fourth floor are still waiting, your button remains lit up because of this.
  5. Once the passenger from the fourth floor selects their destination, take them there.
  6. Once more, wait until passengers have exited before closing doors.
  7. Await the next passenger to select their desired floor, only open doors when you are on said floor, and only close doors when passengers have either exited or stayed on.
  8. Repeat this process with the appropriate floor numbers and in the order that the buttons on each floor have been pressed.

Posted in Elevator Instructions, Lobsterman | 1 Comment

Elevator Instructions—phoenixxxx23

Posted on September 14, 2024 by phoenixxxx23

Elevator: Mission Impossible.

—While moving upwards, disregard all Down Summons Buttons.

—While moving downwards, disregard all Up Summons Buttons.

 —Close the door after 15 seconds of inactivity on any floor.

—When reaching a floor where you’ve been summoned, stop and open the door.

—Respond to all Summons Buttons by heading to the designated floor

—Reverse direction when reaching the top or bottom of the range

—Do not reverse direction unless it is directed to do so or the limit is reached.

Posted in Elevator Instructions, Phoenixxxx | Leave a comment

Instructions for Elevator Operation – lil.sapph

Posted on September 14, 2024 by lil.sapph

Always display the number of current floor and direction in which it is moving with an up or down arrow correspondingly and keep the lights on unless unoccupied. 

Before moving, make sure weight limit is not exceeded. If it is not exceeded, release brakes and proceed. If there is no weight, it is unoccupied 

When “up-button” is pressed on any floor/floors, proceed to and make a stop at said floor/ floors in ascending order, continuing in the upwards direction until the highest “requested floor” is reached, stopping at all floors requested from inside as well. Then you may proceed to respond to “down-button” requests.  

When “down button” is pressed on any floor/floors, proceed to and make a stop at said floor/floors in descending order, starting at the highest “requested floor”, continuing in the downwards direction until the lowest floor requested is reached stopping at all floors requested from inside as well. Then you may proceed to respond to “up-button” requests.

If there are no more “requested floors”, “up-buttons”, or “down-buttons” to respond to, remain at present floor until otherwise requested. 

When completely stopping at a floor,

-Open doors and play “arrival tone” (ding) and pause music, remaining open for 7 seconds, then closing if there are no obstructions tripping the laser and continue “music”.

-If the laser is tripped while closing the doors, open them back up and close again after 7 seconds of no obstructions. 

-Doors may also be closed manually with the “close-door button” if there are no triggers in the laser

-Doors may also be opened manually with the “open-door button” if it is completely stopped at a floor

Light “requested floor buttons” as they are pressed as those represent “requested floors”, each button numbered correspondingly with their floor. 

When reaching a “requested floor”, unlight the corresponding “requested floor button” with the relative floor.

If the “Emergency Button” is pressed, immediately connect the speaker system to the call center and pause “music”

Always play “music” when moving between floors

-“Music” is Surfin’ Bird by The Trashmen on repeat

Posted in Elevator Instructions, lil.sapph | 4 Comments

My Hypothesis—Crabs

Posted on September 14, 2024 by crabs123
  • The impact of WW2 on C.S. Lewis’ theology
  • C.S. Lewis’s individualized theology, which developed as a reaction to the traumas of WW2
  • C.S Lewis’s narrative writing shows the theology of the individual that developed as a reaction to the traumas of WW2
  • C.S. Lewis’s “Chronicles of Narnia” uses narrative writing to reflect a relational Christianity as a reaction to the traumas of WW2
  • C.S. Lewis’s “Chronicles of Narnia” uses narrative writing to present a relational Christian theology in the wake of the traumas of WW2, providing a chance of survival for the Christian faith
  • C.S. Lewis’s “Chronicles of Narnia” uses narrative writing to present a relational Christian theology in the wake of the traumas of WW2. These novels provide a Christian perspective that focuses on a healing relationship with God in a Post-modernist world that presents philosophies such as Existentialism and Nihilism in reaction to war and human struggle. 

#6 C.S Lewis became an Existentialist writer as a result of the traumas he faced in the World Wars

Posted in Crabs123, My Hypothesis | 3 Comments

Elevator Instructions—Crabs(123)

Posted on September 14, 2024 by crabs123

You can eliminate the (123) if you desire, Crabs.
—DSH

  • Open doors when arrived at “destination floor”
  • Close doors after 10 seconds of no motion detected
  • Light any button when pressure is applied
  • When “floor request button” is lit, put coordinating floor in “request queue”
  • If moving “up”, set “destination floor” to the nearest higher floor in “request queue”
  • If moving “down”, set “destination floor” to the nearest lower floor in “request queue”
  • Eliminate request from “request queue” when arrived at “destination floor”
  • When “up button” or “down button” is lit put floor where button is lit on the “request queue”
  • If there are no floors in “request queue” that is higher than “current floor” then set “destination floor” to nearest lower floor in “request queue”
  • If there are no floors in “request queue” that is lower than “current floor” then set “destination floor” to nearest higher floor in “request queue”
  • Update “current floor” each time a floor is reached
  • Close door when “close door button” is lit unless motion is detected
  • Open door when “open door button” is lit
  • When “emergency button” is pressed dial 911 and repeat an automated voice message that says “ Emergency elevator call from “insert address here”
Posted in Crabs123, Elevator Instructions | 1 Comment

Elevator Instructions—student12121

Posted on September 14, 2024 by student12121

Respond to all Summons buttons

  • When arriving at a floor stop then open the doors and keep them open for 5 seconds after the plane of the door is broken, with the timer resetting each time the plane is broken
  • If the summons was an Up summons respond to all destination buttons above the current floor first.
  • If the summons was a Down summons respond to all destination buttons below the current floor first
  • When completing a destination buttons order only respond to summons going the same direction.
  • If multiple destination buttons are pressed prioritize the direction used on the summons and then proximity stopping on the closest floor each time.
  • Prioritize destination buttons over summons buttons
Posted in Elevator Instructions, Student12121 | Leave a comment